Front Lip Installation GuideUpdated a month ago

Tools Required

• Jack and jack stands or ramps (optional but helpful)

• Drill with appropriate bits

• Double-sided automotive tape (3M recommended)

• Self-tapping screws or bolts (included with the lip)

• Cleaning supplies (isopropyl alcohol, microfiber towels)

1️. Preparation

• Jack up the front of the car for easier access.

• Clean the underside of the front bumper.

• Use isopropyl alcohol to remove any remaining grease or wax where the lip will attach.

2️. Test Fit the Lip

• Hold the front lip against the bumper to check alignment and fitment.

3️. Apply Double-Sided Tape (If Applicable)

• Apply 3M automotive-grade double-sided tape along the edge of the lip that will contact the bumper.

• Peel a few inches of the backing off to make it easier to apply later during final positioning.

4️. Install the Lip

• Align the lip with the bumper using your markings or masking tape as guides.

• Press firmly if using tape.

• While holding the lip in place, begin installing screws or bolts starting from the center and working outward.

5️. Final Adjustments

• Make sure the lip is centered and flush against the bumper.

• Tighten all fasteners securely.

• If using tape, press and hold for 30+ seconds to ensure strong adhesion.

✅ Installation Complete!
You're now ready to enjoy your upgraded BMW.